IP139 Emergency vehicle Lights, head lights, tail lights, red top lighs for N scale and HO scale by Iron Penguin

Add realism to your HO scale or N scale emergency vehicles with this easy to install lighting kit. The wires are already soldered to the LED chip, so all you have left to do is install on your vehicle. This can be achieved by drilling a small hole through the vehicle, thread the wires through the vehicle and attach to the circuit board located either under the layout or in a nearby building.
The photo is from Jim In PA who used this kit to light is HO vehicle.

IP139 comes with headlights, 2 red top lights, and flashing red tail lights. Follow the schematic for flashing tail lights or to make tail lights alternate instead of flash, attach 1 of the resistors to each of tail lights and attach to the same hook-up as the headlights. Before permanently attaching the LEDs check the color using the circuit board or a 3v battery. The wires no longer indicate the color. They are also very delicate and the wire can come off the LED. The power source can be AC/DC 6-12 volts. The size of the chip is a 603 (Nano) replaces IP108

DOES NOT INCLUDE THE VEHICLE